News

To contact us,please using the contact from in our
Contact Page

Do you know how to connect cable and battery terminals correctly?!

The wrong connection between cable and battery could be damaged your battery.

⚠ Warning! Never put the lock washer between the cable and the terminal. The cable end must be directly in contact with the terminal. Failure to do so may result in a melted terminal and voiding of your warranty.

Cable size has a direct influence on the voltage drop across the system. The following are guidelines. An electrician should verify that your system is correctly sized and installed. Cables must be sized according to the expected load using the following table!

 

If you need any further information, please contact us!

Email: lcb@lcb.tw

#LongChangBattery #LCB #Vietnamfactory #taiwan

#tipsbattery #connections #cables #terminals

 

***

Table values are from NEC table 310.16 for cop-per cables rated at 167˚F (75˚C), operating at an ambient temperature of no more than 86˚F (30˚C). Lengths in excess of 6 feet (1829mm) may require heavier gauge wire to avoid unacceptable voltage drop. In series/parallel banks, it is preferable for all series cables to be the same length, and all parallel cables to be the same length.